![]() Turn the air conditioning and the rear defrost off and accelerate to 55 mph under moderate and constant acceleration. The ignition key must not be left on prior to the cold start otherwise the heated oxygen sensor may not run.ģ.Ěs soon as the engine starts, idle the engine in drive for 2 1/2 minutes with the air conditioning and the rear defrost on.Ĥ. Coolant temperatures must be below 122 ☏ and the difference between coolant and air temperatures read by the sensors must be within 11 degrees.Ģ. The generic drive cycle begins with a cold start. Important! If you choose to use this generic drive cycle, you must obey all traffic laws and drive in a safe manner.ġ. The original engine within my vehicle has been removed and replaced, what emission control equipment is now required? Waivers and extensions will not be granted for vehicles with tampering-related emissions test failures in accordance with federal guidelines (40 CFR 51.360(a) (3)). Consumers should be aware that if the emissions control device is not working properly and is still intact on the vehicle and the vehicle is under eight (8) years old and under 80,000 miles, they may qualify for a manufacturer warranty for emissions control devices. “Tampering” is defined by the Clean Air Act of 1970 (revised in 1977) to be the removal or rendering inoperative of any emissions control device or element of design installed on or in a motor vehicle or its engine in compliance with federal regulations prior to its sale and delivery to the ultimate purchaser, or for any person knowingly to remove or render inoperative any emissions control device or element of design after such sale and delivery to the ultimate purchaser (Clean Air Act Section 203(a)(3)(A)).įor the purposes of the Canyon County and City of Kuna I/M vehicle emissions testing program, vehicles that are found without emissions control devices will fail the emissions test until the vehicle is brought back into compliance with manufacturer emissions control device specifications. To remove or render inoperative any emissions control device or element of design installed on or in a motor vehicle or its engine in compliance with federal regulations is prohibited and constitutes “tampering.” The purpose of the visual inspection is to ensure the vehicle has all the emissions control devices originally required by the manufacturer pursuant to the requirements of the Clean Air Act and they appear to be in good working order. This program was established based on EPA standards, which state that a visual inspection shall be conducted on all applicable model years. How can I be sure I will be notified when my emissions test is due? Make sure the Idaho Department of Transportation has your correct address, notices are mailed to the address on record with ITD. Notices will be sent to the address on record with Idaho Department of Transportation. ![]() ![]() This notice will also detail what vehicle needs testing and list available testing stations in Canyon County. The Final Notice will be sent at the end of the 30 day testing period reminding the motorist that they failed to complete the test and if they do not complete the test within the next 35 days from the date of the notice, their vehicle registration will be revoked by ITD.Motorists will have until the end of the designated month to complete the required emissions test. The Initial Notice will detail what vehicle needs testing and list available testing stations in Canyon County.Yes, motorists will be sent no less than two notices to complete an emissions test or received an approved waiver, exemption or extension for their applicable vehicle before the registration is subject to revocation.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |